How do you fix the LF code on a Whirlpool Cabrio washer?
LF in the display
Check the water inlet hoses to be sure they are not clogged or kinked. You may also need to check the screens on the washer water inlet valve. This means shutting off the water supply, and disconnecting the water inlet hoses from the washer.
How do I reset my Whirlpool Cabrio washer?
Press the Start Stop button once. Rotate the dial until Rinse, Wash, and Stop light illuminate. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.
How do I clear the error code on my Whirlpool washer?
To remove the code, press pause or cancel button twice and the power button once. If the code is still displayed, unplug the washer or disconnect the power for one minute. Items were detected in the washer during the Clean Washer cycle. Remove items from the drum and restart the Clean Washer cycle.
How do you run diagnostics on a Cabrio washer?
How do I reset my Cabrio touch washer?
This is the first step you are done to reset the Whirlpool Cabrio washing machine.
- Press PAUSE/CANCEL twice to cancel the cycle. The washer will drain.
- Press POWER.
- Select the desired wash cycle.
- Select the desired Modifiers and Options.
- Press START.
What does LF on my washer mean?
too long to fill
If F8 E1 or LF (too long to fill) appears in display, the washer is taking too long to fill. … Either the F8E1 or the LF error codes may indicate there is some problem with the water supply going to the washer. Please make sure both inlet hoses are connected and both hot and cold water supplies are turned on.
What does FOD mean on Whirlpool washer?
Fod or F18 is displayed:
Excessive foam formation, or suds, interrupted the program/cycle.
Is there a reset button on a washing machine?
Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. … Some machines have a button you push to reset its motor. On a machine without a reset button, unplugging the washer and then plugging it back in often serves as the means to reset it.
What does lf mean on Whirlpool dryer?
An LF (Lint Filter) Error Code indicates that the HybridCare™ filter has been removed. Place filter into dryer and make sure the handle is properly seated.
How do I reset my Whirlpool front load washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.
How do you unlock a Whirlpool washing machine?
Hold down the “Control Lock” button on your Whirlpool washer for three seconds at the end of the washing cycle. Listen, and when you hear the unlatching sound, the door should open.