How do I reset my Litter-Robot 3?
To Hard Reset the unit, please do the following: Turn the Power Off and unplug the Power Supply from the Base of the unit. Remove the Bonnet from the unit and set it aside, then remove the Globe and set it aside making sure that it does not roll.
How do I reset my Litter-Robot 2?
Make sure that the green light on the Litter–Robot Control Panel is on (“OK/Waiting”). 3. If the red light is on (“Sensor/Timing”), push any of the buttons (Cycle, Fill, or Empty). This resets the unit and the green light should come on (“OK/Waiting”).
Why does my litter-robot stop mid cycle?
Have you ever found your Litter–Robot stopped in mid rotation and possibly with the red light blinking? This could be a sign that your cat sensor needs adjustment. If the Cat Sensor is triggered continuously for more than 2 minutes then the red light starts to blink.
Why is my litter-robot not connecting to WIFI?
Reboot your router. Completely close the Litter–Robot app. While the unit is at the Home position with the solid blue light, unplug your unit from the base, not the wall. Wait 15 seconds, plug it back in, and allow it to cycle until the solid blue light comes on (“Ready” status).
Why is the red light blinking on my litter-robot?
Litter–Robot flashing red light
A flashing red light indicates that the cat sensor has been activated continuously for 2 minutes or more by either too much weight in the unit or your cat not leaving the unit.
Why does my Litter Robot keep saying it’s full?
Debris may cause the DFI to indicate a full drawer regardless of the waste in the drawer. Once you are done cleaning your unit, let it dry fully and then reassemble it. If it is not dry, the litter will clump prematurely and may get clogged in the ports or litter pocket.