How to remove toothpaste stains

If the toothpaste does not contain titanium dioxide and the fabric does not water spot (water can often leave spots on dark silks), use a white cloth dipped in plain cool water to remove the stain. Gently rub the spots with the cloth and then blot with a dry white cloth to remove moisture.

Apply an oil solvent, available at drugstores, and let dry, then remove as much residue as possible. Treat with a liquid detergent (like Woolite) and very little water. Rub to form suds, then rinse. Use an eyedropper and diluted vinegar to remove any remaining color.

The short answer is unfortunately no, not all stains can be removed, and here are three reasons why. The longer a stain is left untreated, the less likely it is to be removed. So when a neglected stain is finally addressed and actually removed, the fabric where the stain once sat is now a different color.

Yes, they are. Douse the stain with white vinegar, then apply a paste made of equal parts baking soda and vinegar. If this doesn’t work, immerse the item overnight in a bucket of water containing a few tablespoons of detergent and vinegar. Rinse and wash the following morning.

The most important thing, no matter what kind of stain you’re dealing with, is to prevent it from setting. “Setting” is an informal term that refers to the staining material forming a chemical bond with the fabric. At that point it is effectively permanent.

Saturate set-in stains with vinegar, then rub the spot with a paste made from equal parts vinegar and baking soda. You can add a couple of tablespoons each of vinegar and laundry detergent to a bucket of water and soak the garment overnight ​if the stain persists. Then, rinse and wash.

Using too much stain remover

Using too much can make the area harder to rinse or dry, especially on carpets and upholstery. Light, repeated applications of a remover work much better than flooding a stain.

Clothing with vinegar and bleach

Nope. Mixing vinegar with bleach creates toxic chlorine gas. When mixed with water, the gas creates hydrochloric and hypochlorous acids. The gas by itself isn’t good for you, and it’s even worse for your clothing.

Bonus tip: Break down stains with baking soda

To make a pre-treating paste, combine 6 tablespoons of ARM & HAMMER™ Baking Soda with ⅓ cup warm water. Test it on the garment first to check for colorfastness (color bleeding or fading) then rub the paste onto the stain, let dry, then toss in the wash.

Distilled White Vinegar

White vinegar is key to removing yellow underarm perspiration stains and odor, removing mildew stains, whitening and brightening your clothes.

Smelly Stains

Stains that have a really bad odor benefit from baking soda as a pre-treater. Dried baking soda sucks up moisture and laundry odors as it sits in contact with them. Pouring baking soda on a wet stain and allowing it to sit can help remove both the stain and the odor.

Some people add salt to a load of clothes to set the color, while some swear by the idea that adding distilled white vinegar to the wash or rinse water will set the dye. Unfortunately, neither method will work reliably to prevent dye bleeding from clothes or fabrics that have already been commercially dyed.

To start, dissolve oxygen bleach in hot water, then add enough cold water to cool the mixture. Soak the garment in this solution for 15-30 minutes, then rinse. If the stain remains, try wetting the stains with 3% hydrogen peroxide. Allow it to sit for a few minutes and then rinse thoroughly.

Mix a solution of oxygen bleach and cool water in a washtub or sink, following the product instructions. Submerge the stained items, and allow them to soak for at least eight hours.

chlorine bleach. If clothes contain color, use color-safe bleach. (1 C white vinegar can be substituted instead of bleach.) Agitate 5 more minutes, then turn machine off and let soak 15 more minutes.

If you have already dried the clothing or the dye transfer is very heavy, you will need to soak the clothing before rewashing. Mix a solution of oxygen-based bleach (such as OxiClean, Nellie’s All Natural Oxygen Brightener, or OXO Brite) and cool water. Do not use oxygen bleach on silk or wool.

Rubbing alcohol

To use as a dye remover, pour a small amount of rubbing alcohol onto a cotton ball or cotton pad. Gently dab it on the stained portion of your skin. Once the dye is off, be sure to rinse the area with warm water and soap.