Where do I put my wahoo cadence sensor?
The RPM Cadence Sensor is designed to mount on the inside of the non-drive side crank arm. Placing it on the outside of your crank arm can cause interference by scraping against your shoe. Likewise, installing the RPM on your drive side crank arm may rub and cause interference with your drivetrain.
How do you install a cadence sensor?
How do you fit a Wahoo speed and cadence sensor?
SETUP
- Slide the Wahoo RPM Cadence pod into the silicone mount.
- Thread one zip-tie through the slot on each side of the silicone mount.
- Place the Wahoo RPM Cadence on the inside of the non-drive side crank arm.
- Slide the zip-ties through, tighten them down, and trim the excess part of the zip-tie.
Where does the Wahoo speed sensor go on a spin bike?
1 – Place the Wahoo Speed Sensor on your spin bike
First, I placed the Wahoo Speed Sensor on the outside of the front wheel so that it would get the most rotation. It was an easy setup. I used a video I found on YouTube as guidance – “Garmin Speed Sensor Review + Spin Bike/Trainer/Indoor Setup”.
Can you use Zwift with just a cadence sensor?
A wheel speed sensor
The sensor will transmit to your device using ANT+, Bluetooth or both. Check that the signal is supported by the device you‘re planning to run Zwift on. You can also use a cadence sensor and, although this isn’t necessary for Zwifting, it’s a useful metric.
How long do Wahoo sensor batteries last?
CR2032 replaceable coin cell battery. Lasts up to 12 months.