Can I install Trex myself?
Build Your Own Deck
Trex® engineered composite decking to be as simple to install as it is to care for. And to make it even easier, we’ve compiled all the resources you need to build a DIY deck.
How are Trex boards attached?
To install composite decking with a hidden fastening system, start at the house by face-screwing the first board. Next, screw a hidden fastener clip into the groove on top of each joist. Then, slide the groove of the next board into the clips and tighten with a rubber mallet.
Do you gap Trex decking?
You must gap Trex® decking, both end-to-end and width-to-width. Gapping is necessary for drainage and the slight thermal expansion and contraction of Trex decking boards. Gapping also allows for the shrinkage of the wood joist system.
Can you screw down Trex decking?
The answer is yes for a solid composite decking (must be pre-drill and must check with manufacture). You can not drill or screw through a hollow composite deck as the screw will become loose and rise in time . Like the usual wooden decking boards, you can also screw down a solid composite decking.
Do you need special screws for Trex decking?
Trex recommends the use of two screws per joist.
All recommended screws are designed to be installed flush with decking surface. DO NOT countersink screws. Use recommended stainless steel screws in any areas near bodies of saltwater. 2-3/4″ or 3″ screws can be used with Trex 2×6 product.
Do you pre drill Trex?
You do not have to pre– drill with Trex Escapes. Composite decking is a great alternative to traditional wood decking. When building your deck and railing, it is recommended that code-approved structural material be used as the framing and joists.