Can you cut Neon Flex light?
THE MOST VERSATILE AND SIMPLE LIGHTING SYSTEM YOU WILL EVER USE LED Neon Flex is a green friendly, safe, low voltage, DIY, easy to install, lineal long life lighting system that can be simply bent and cut to whatever your design requires for both indoors and out!
Can you cut smart Neon Flex?
The LED light strip features a variety of cutting marks to its edges so all you have to do is make an even cut at the point of connection using a sharp cutting blade. It’s important to use a sharp blade as this will ensure a straight cut and you will also avoid pulling any internal wires.
How do you cut neon flexible strip lights?
How to cut LED Neon Flex
- Disconnect the LED strip from power.
- Lay the strip on a firm surface then make a straight and even cut through the strip.
- Avoid bending or pulling the Flex whilst cutting, as this could result in an uneven cut and damage the LED strip held within the Flex.
Can you cut neon rope light?
All LED Neon Flex rope light is cuttable on 1.5′ cut marks. Rated IP65 so it can be used for all indoor and outdoor applications. All LED’s are spaced 1/3” apart with a 120-degree beam angle wired parallel so if one LED goes out the rest stay lit.
What is flex neon?
How do you join a Neon Flex?
To connect two pieces of neon flex, use a joiner, or for a very close connection use a pin connector and seal with silicone and heat-shrink. Push the sharp ends of the joiner pins into the wires of one section of the neon flex, just like installing the pins for the power cord in the section previous.
Where do you cut Neon Flex?
Locate the cutting mark on the side of the LED Neon Flex. This will be designated by a vertical dashed line. Using heavy-duty sheers or a utility knife, make an even cut through the LED Neon Flex exactly on the mark. If you are off the mark the product can be damaged.
Can you cut neon wire?
Yes, EL Wire can be cut at any point along the line and will continue to glow to the point where it is cut. We recommend to cut at a 30° angle and immediately after cutting to apply an end cap to the wire. This will keep debris and moisture out of the wire and keep it lasting time after time.
How do you cut LED flex strips?
How do you cut and solder Neon Flex?
Can you cut rope lights to size?
Rope light spools can be cut using either sharp scissors or a knife. To cut rope light, measure the area where you plan to install the rope light and then cut the tube at the nearest cutting mark. … This is the only place that LED or incandescent rope light should be cut.
What is LED Neon Flex?
Flexible LED Neon Rope Lights. LED Neon Flex lights are a breakthrough in flexible lighting design. With their unique construction, these flexible lights can directly replace traditional glass neon with better performance, lower cost, and easier maintenance.