AUTOMATIC HAND DRYER WITH TEMPERATURE DISPLAY

ABSTRACT

This project deals on the design and construction of automatic hand dryer with temperature display facility which is capable of drying a wet hand placed under its vent goes of automatically. It corporate a temperature sensing and displays unit which displays the temperature of the blown out air. This system is designed in top-down methodology using passive and active components sensors (LM35 & LDR) at the input to sense temperature and hands respectively. The control unit is made up of signal conditioning unit, voltage comparator and frequency generator, and decimal counting unit. The output interface comprises transistor, driver, actuator, Electromagnetic relay and a –digit seven segment Display. The sensor are installed at the front of the blower and this device dries with warm air only. When a hand is placed under the vent to block the line of sight of the LASER Diode and LDR, the blower gets actuated and blows warm air. As the hand is removed, the blower stops automatically along side the temperature display. The principle behind the work of this system is that the hands must be opaque enough to block the line of sight of the opto coupler. This removes the stress, time and dangers associated with push button type. The result being automatic hand dryer with temperature display.

TABLE OF CONTENTS

Abstract

CHAPTER ONE

1.0    Introduction

1.1   Background of Study

1.2   Statement of Problems

1.3   Research Objectives

1.4   Research Question

1.5   Research Hypothesis   

1.6   Scope of Study

1.7   Significance of study

1.8   Limitation of study

1.9   Definition of terms

CHAPTER TWO

2.0   Literature Review

CHAPTER THREE

3.0   Research methodology

3.1   Research Design

3.2   Population of study

3.3   Sampling Design and Procedure

3.4   Data Collection Instrument

3.5   Administration of Data Collection Instrument

3.6   Methods of data analysis

CHAPTER FOUR

4.0   Data Presentation and Analysis

4.1   Data Presentation  

4.2   Test of Hypothesis 

CHAPTER FIVE

5.0   Summary, Conclusion and Recommendation

5.1   Summary

5.2   Conclusion

5.3    Recommendation

References

Questionnaire

You May Also Like

EFFECT OF MOTIVATION ON STUDENTS ACADEMIC ACHIEVEMENT AND INTEREST IN SENIOR SECONDARY SCHOOL BIOLOGY IN MAKURDI METROPOLIS

Motivation is force used within the educational setting to encourage student learning and understanding. Motivation and achievement have long been recognized to have a close cause effect relationship on ability and achievement. The anticipated relationship is that, the higher the motivation ability the higher the expected level that is why the issue of motivation of students and the impact of academic performance are considered as important aspects of effective learning. Based on this background, this research investigated the effect of motivation on the academic achievement and interest of students in secondary school biology in Makurdi metropolis. Five schools were randomly selected from among the secondary schools in Makurdi metropolis. The study made use of a quasi-experimental design of the equivalent control group. The finding revealed that the students taught using motivation achieved more and those taught without motivation achieved less. Both male and female students exposed to motivational approach performed competitively better in the achievement test. There was also no significant difference in the mean interest rating of male and female students. This study has therefore shown that biology is one of such areas where the use of motivation may be beneficial.
Read More